background image

Echoflex Installation Guide

Phase Adaptive Dimmer

Phase Adaptive Dimmer (ER6CD/ER12CD)

 Page 9 of 12

Echoflex

Compliance

For current and complete compliance information, see the Echoflex Phase 
Adaptive Dimmer datasheet at 

echoflexsolutions.com

FCC Compliance

Echoflex Phase Adaptive Dimmer

(For any FCC matters):
Echoflex Solutions, Inc.
3031 Pleasant View Road
Middleton, WI 53562
+1 (608) 831-4116

echoflexsolutions.com

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference when the equipment is operated in a commercial environment. This 
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used 
in accordance with the instruction manual, may cause harmful interference to radio 
communications. Any modifications or changes to this product not expressly approved by 
Electronic Theatre Controls, Inc. could void the user’s authority to operate the product. Operation 
of this equipment in a residential area is likely to cause harmful interference in which case the user 
will be required to correct the interference at his own expense.

Contains FCC ID: SZV-STM300U

ISED Compliance

This device contains a license-exempt transmitter/receiver that complies with Innovation, Science, 
and Economic Development Canada’s license-exempt RSSs. Operation is subject to the following 
two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired 

operation of the device.

Contains IC ID: 5713A-STM300U

Conformité ISDE

Cet appareil contient un émetteur/récepteur conforme aux CNR d'Innovation, Sciences et 
Développement économique Canada (ISDE) applicables aux appareils radio exempt de licence. 
Son fonctionnement est soumis aux deux conditions suivantes:

1. L'appareil ne doit pas produire d'interférences.
2. L'utilisateur de l'appareil doit accepter toute interférence, même si l'interférence est 

susceptible d'en compromettre le fonctionnement.

Contient ID IC: 5713A-STM300U

Summary of Contents for Echoflex ER12CD













Reviews: