Each
AR 250
utilizes
6 channels
of
DMX 512
signal for complete control.
To ensure that each unit accesses the correct signal, it is necessary to correctly address each fixture. Any number between 1 and 506
can be generated via the multifunction panel of the unit
AR 250
.
This procedure must be carried out on every unit being utilized.
When powered up initially, each projector will show
A001
which indicates
DMX
address
1
; a projector thus addressed will respond
to commands on channels
1
to
6
from the
DMX 512
controller. A second projector should be addressed as
7
a third as
13
and
so on until the final unit has been addressed.
DMX 512 should be carried out so that there is no overlap in the assigned addresses. This will allow your controller to accurately
address each individual parameter of your
AR 250
s.
altering dmx addresses
1) Press the + or - buttons until the display shows the DMX address required. The characters in the display panel will flash to indicate
that the selection is not stored in memory.
2) Press the enter button to confirm your selection; the display will stop flashing and the projector will now respond to the new
DMX 512 settings.
3) To better understand the functions of each DMX 512 we refer you to section 14 “Operation via DMX 512”.
Important Note: Keeping the + or - button pressed will cause the display to alter at increase speed, allowing a faster selection to be
effected.
Note: Channel order and function table can be found on page 20.
A001
menu
enter
+
11. DMX addressing
English
14
Summary of Contents for Irideon AR250
Page 1: ...instructions manual ...
