ETC Source Four Mini LED, User Manual

6

Step 1:

Release the retaining clip by gently 

pushing it up.

Step 2:

Insert the color frame.

Step 3:

Lock the retaining clip by gently pushing it 

down. 

Additional accessories are available for the Mini that 
also fit into the color frame holder including the top 
hat, short top hat, half hat, short half hat, and donut. 
When an accessory is used, the color frame should be installed in the rear slot of 
the holder.

Using a C-clamp

A miniature c-clamp is available (sold separately) for use with the Source Four Mini 
Low Voltage luminaire.

Step 3:

Loosen the c-clamp yoke bolt and rotate the yoke to the desired position.

Step 4:

Tighten the bolt to lock the luminaire.

N o t e :

Always insert the color frame open side down.

C A U T I O N :

Tighten the c-clamp pipe bolt to about 18in/lbs. (Approximately finger 

tight plus up to one-quarter turn.) Do not use excessive force.

N o t e :

The Source Four Mini yoke has a c-clamp hole with a .406” diameter.

Retaining 

clip

Color 

Frame 

Holder

Yoke bolt

Pipe bolt

c-clamp

The c-clamp attaches the luminaire yoke and allows 
you to adjust the position of the luminaire once it is 
mounted to a pipe (fits to a 3/8” to 1” pipe).

Step 1:

Tightly fasten the c-clamp to the yoke with 

the provided yoke bolt and lock washer.

Step 2:

Place the c-clamp on the mounting pipe, 

and then tighten the pipe bolt to secure it.