Error Codes
24
Error Codes
When you apply power to the fixture, it runs a calibration (homing) sequence and displays any
errors that it detects.
Example:
For example, when the display shows "Gobo Wheel Sensor", it means the
gobo wheel sensor was not present when the calibration (homing) process occurred.
When multiple errors are present they will cycle on the display twice, and then the
fixture will reset (restart). Any errors that remain after two reset cycles are not
correctable by a reset alone and will require service. Please contact support for
technical assistance.
Gobo Wheel Sensor
This message displays after the reset of the fixture if any of the following conditions exist:
•
the Hall sensor has malfunctioned
•
the magnet is missing from the gobo wheel
•
the motor or sensor wire harness is disconnected or damaged
•
there is an obstruction, preventing the wheel from moving during homing
•
the drive motor has malfunctioned
•
the motor driver circuit has malfunctioned
Boot Diff
This message displays after the reset of the fixture if the bootloader for one of the Boot Sectors
does not match the copy of the bootloader stored in the system.
Color Wheel Sensor
This message displays after the reset of the fixture if any of the following conditions exist:
•
the Hall sensor has malfunctioned
•
the magnet is missing from the color wheel
•
the motor or sensor wire harness is disconnected or damaged
•
there is an obstruction, preventing the wheel from moving during homing
•
the drive motor has malfunctioned
•
the motor driver circuit has malfunctioned
Driver Board 1 NR
This message displays after the reset of the fixture if any of the following conditions exist:
•
the driver board has malfunctioned
•
the driver board power or data wire harness is disconnected or damaged
EE-R Write
This message displays after the reset of the fixture if an error has been detected writing to the
internal setting memory. If this error is encountered, you may have a bad display PCB. Contact
technical support for assistance.
