Error Codes
26
Tilt Driver Fault
This message displays after the reset of the fixture if any of the following conditions exist:
•
the tilt driver board is above operating temperature
•
the driver board power or data wire harness is disconnected or damaged
Tilt Encoder
This message displays after the reset of the fixture if any of the following conditions exist:
•
the tilt lock is engaged
•
the magnetic encoder has malfunctioned
•
the motor driver circuit has malfunctioned
•
the drive motor has malfunctioned
•
the motor or encoder wire harness is disconnected or damaged
Tilt Encoder Time Out
This message displays after the reset of the fixture if any of the following conditions exist:
•
there is an obstruction preventing the unit from correcting itself too long
•
the tilt lock is engaged
•
the magnetic encoder has malfunctioned
•
the encoder wire harness is disconnected or damaged
Tilt Sensor
This message displays after the reset of the fixture if any of the following conditions exist:
•
the Hall sensor has malfunctioned
•
the magnet for the Hall sensor is missing
•
the motor or sensor wire harness is disconnected or damaged
•
the drive motor has malfunctioned
•
the drive motor circuit has malfunctioned
•
the tilt belt is broken
Zoom 1 Sensor
This message displays after the reset of the fixture if any of the following conditions exist:
•
the Hall sensor has malfunctioned
•
the magnet for the Hall sensor is missing from the zoom slide
•
the motor or sensor wire harness is disconnected or damaged
•
the drive motor has malfunctioned
•
the drive motor circuit has malfunctioned
•
the zoom 1 belt is broken
Zoom 2 Sensor
This message displays after the reset of the fixture if any of the following conditions exist:
•
the Hall sensor has malfunctioned
•
the magnet for the Hall sensor is missing from the zoom slide
•
the motor or sensor wire harness is disconnected or damaged
•
the drive motor has malfunctioned
•
the drive motor circuit has malfunctioned
•
the zoom 2 belt is broken