409-35011
Rev D
76
of 83
7. With the other hand, carefully pull on the cutting arm to slide the quick-change arm assembly off the
pivot pin (Figure 96).
Figure 96: Sliding the assembly off the pivot pin
Replacing the contour blades
DANGER
The contour blades are extremely sharp. Handle with caution.
Preparing the machine for tooling changeover
on page 73).
2. Remove the quick-change arm assembly from the machine (see
on page 74).
3. While holding the cutting arm in place to prevent rotation, use a 3 mm hex-head wrench to loosen
the M4 socket head cap screw (Figure 97). Do not remove the screw.
Figure 97: Removing the contour blade
1
Dowel pins
2
Contour blade
3
M4 socket head screw
4. Pull the blade straight off the dowel pins and remove it from the face of the cutting arm.
