409-35011
Rev D
78
of 83
Replacing the mandrel
Preparing the machine for tooling changeover
on page 73).
2. Retrieve the mandrel changeover tool (Figure 99) from the tooling holder (Figure 91)
Figure 99: Mandrel changeover tool (2359204-1)
3. Place the mandrel changeover tool onto the mandrel (Figure 100). You will feel engagement as the
wings of the tool go into the slots in the machine.
Figure 100: Mandrel
DANGER
The mandrel tip and contour blades represent dangerous cut and puncture hazards. Use
extreme
caution when working in
their vicinity.
4. Turn the tool counterclockwise to loosen the mandrel.
5. Carefully remove the mandrel.
6. Place the new mandrel into the changeover tool.
7. Insert the tool and mandrel into the mandrel shaft
8. Using a torque wrench, turn the tool clockwise to tighten the mandrel to 4 Nm. Do not overtighten.
