409-35011
Rev D
66
of 83
Advanced Settings
The Advanced Settings option if additional adjustments are necessary after all adjustments in the
standard setup mode have been attempted. The parameters that can be edited for each step in the
process are displayed when that step is selected in the Process Steps box (Figure 79).
To select Advanced Settings, touch the
icon. The icon is highlighted in blue (Figure 81) to
indicate that the Advanced Settings are selected.
Insulation
–
Type II Coarse Cut
Figure 81 shows the advanced settings for Insulation
–
Type II Coarse Cut.
Figure 81: Advanced settings for Insulation
–
Type II Coarse Cut
The advanced settings for Insulation
–
Type II Coarse Cut are listed in Table 10. These settings all
relate to the current diameter, which is controlled by the Settings for each process step (Figure 80).
Table 10: Advanced settings for Insulation
–
Type II Coarse Cut
Setting
Description
Speed
The speed at which the cutting arms rotate around the cable.
Rotations at cut diameter
The number of times the cutting arms rotate at the current diameter.
Rotations to close blades
The number of rotations the cutting arms take to reach the current
diameter from their home position.
Number of pieces
The number of cutting operations the machine performs on each layer.
Set to 1 for the best cycle time.
Increase the value when scrap pieces become too large to
successfully remove, or when scrap removal becomes an issue.
