SYSTEM SET UP PROCEDURE
A. AS A "SHELF SYSTEM" (TABLE TOP USE)
- INCLUDED 1 PC BASE FOR THE MAIN UNIT ( )
FIXING THE BASE TO THE MAIN UNIT:
1. PLACE THE BASE UNDER THE MAIN UNIT,
2. SLIDE THE BASE FROM RIGHT TO LEFT (SEE DIAGRAM BELOW).
3. STOP WHEN ARROWS ARE ALIGNED (SEE DIAGRAM). THE BASE IS NOW LOCKED
TO MAIN UNIT.
(TO RELEASE THE BASE FROM THE MAIN UNIT, SLIDE THE BASE FROM RIGHT TO LEFT
(OPPOSITE DIRECTION) UNTIL IT BECOMES RELEASED.
- INCLUDED 2 PCS BASE FOR THE SPEAKERS ( )
FIXING THE BASE TO THE SPEAKER BOX (LEFT/ RIGHT):
1. PLACE THE BASE UNDER THE SPEAKER,
2. SLIDE THE BASE FORWARD UNTIL YOU HEAR A "CLICK" SOUND,
THEN THE BASE WILL LOCKED. (TO RELEASE THE BASE FROM THE SPEAKER,
LIFT THE LATCH AT THE REAR OF THE BOTTOM OF THE SPEAKER BOX AND
PUSH FORWARD, THEN THE BASE WILL BE UNLOCKED).
"CLICK"
1.
2.
3.
3.
LOCKED WHEN
ARROWS ALIGN
1.
2.
SLIDE UNTIL LOCKED
(ARROWS ALIGNED)
LOWER THE
SPEAKER BOX
ONTO THE BASE
SLIDE THE BASE
FORWARD UNTIL
IT LOCKS
WHEN THESE
ARROWS ARE ALIGNED
THE BASE IS PROPERLY
INSTALLED ONTO MAIN UNIT
110 MM
(8.1")
WALL MOUNT
SCREW GUIDE
WALL MOUNT
SCREW GUIDE
B. AS A "WALL MOUNT SYSTEM"
CONNECTION OF SPEAKER BOXES
- PLACE THE SPEAKER BOXES AS FAR APART AS POSSIBLE FOR BEST SOUND EFFECT.
- UNWRAP THE SPEAKER-CORDS OF BOTH SPEAKER-BOXES.
- INSERT THE "RED" WIRE OF THE LEFT SPEAKER-BOX INTO THE "RED" ( + ) SPEAKER
CONNECTOR BEHIND THE MAIN-UNIT, WHICH HAS THE "L" INDICATION (UNDER THE
SPEAKER-CONNECTOR).
- INSERT THE "BLACK" WIRE OF THE LEFT SPEAKER-BOX INTO THE "BLACK" ( - )
SPEAKER CONNECTOR BEHIND THE MAIN-UNIT, WHICH HAS THE "L" INDICATION
(UNDER THE SPEAKER-CONNECTOR).
- REPEAT THE ABOVE 2 STEPS FOR THE RED & BLACK WIRES OF THE "RIGHT"
SPEAKER BOX, BUT THIS TIME, INSERTING THEM INTO THE RED & BLACK
CONNECTORS WITH THE "R" INDICATION.
- WHEN INSERTING EACH WIRE INTO A CONNECTOR, PRESS DOWNWARDS ON
THE CONNECTOR'S PLASTIC KNOB (RED OR BLACK PART) & PUSH THE EXPOSED
METAL END OF THE WIRE ALL THE WAY INTO THE HOLE ABOVE THIS KNOB.
USE THE BASE OF MAIN UNIT
AS A "TEMPLATE" FOR FIXING
THE 2 SCREWS ON THE WILL.
THE 2 GUIDE HOLES (SEE DIAGRAM)
WILL HELP YOU TO OBTAIN EXACT
LOCATIONS OF THE SCREWS.
ONCE YOU HAVE MOUNTED THE MAIN UNIT IN IT'S INTENDED LOCATION,
FIX THE SPEAKER POSITIONS AS DESIRED. PLEASE TAKE CARE TO LEAVE
ENOUGH ROOM FOR THE SLIDING CD-DOOR TO OPEN (SEE DIAGRAM BELOW).
E-9
E-10
