ETEKCITY ESF28 Series, User Manual

20

FCC Statement

FCC Radiation Exposure Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 

two conditions: 

1.

 This device may not cause harmful interference, and 

2.

 This device must accept any interference received, including interference  that 

may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for 

compliance could void the user’s authority to operate this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates, uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the 

user is encouraged to try to correct the interference by one of the following measures:

•  Reorient or relocate the receiving antenna.

•  Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected. 

•  Increase the separation between the equipment and receiver. 

•  Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an 

uncontrolled environment. End users must follow the specific operating instructions 

for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure 

compliance requirements, please follow operation instructions as documented in this 

manual. This transmitter must not be co-located or operating in conjunction with any 

other antenna or transmitter. This equipment should be installed and operated with 

a minimum distance of 20 cm between the radiator and your body. The availability of 

some specific channels and/or operational frequency bands are country dependent 

and are firmware programmed at the factory to match the intended destination. The 

firmware setting is not accessible by the end user.