Model:
CF28PIR
Flush Ceiling Fitting with Integral PIR Detector
These instructions are provided as a guideline to assist you.
PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLATION
AND RETAIN FOR FUTURE REFERENCE
Pack contents:
1 x Flush fitting with Integral PIR
1 x GR10q 4 pin DD 28W lamp
INSTALLATION INSTRUCTIONS
A guide for qualified electricians
Issue 2014
FOR PRODUCT ADVICE:
• T: 01933 673 144
• F: 01933 678 083
• E: sales@eterna-lighting.co.uk
Visit our website:
www.eterna-lighting.co.uk
EVENTUALLY, YOU MAY WANT TO
REPLACE THIS PRODUCT:
Regulations require the recycling of Waste from
Electrical and Electronic Equipment (European
“WEEE Directive” effective August 2005—UK
WEEE Regulations effective 2nd January 2007).
Environment Agency Registered Producer: WEE/
GA0248QZ.
WHEN YOUR PRODUCT COMES TO THE END OF
ITS LIFE OR YOU CHOOSE TO REPLACE IT, PLEASE
RECYCLE IT WHERE FACILITIES EXIST - DO NOT
DISPOSE WITH HOUSEHOLD WASTE.
CLEANING:
Disconnect the power and clean the exterior only of
this fitting with a moist (not wet) cloth.
Do not use any chemical or abrasive cleaners.
IF YOU EXPERIENCE PROBLEMS:
If you believe your product is defective, please return
it to the place where you bought it. Our Technical
Team will gladly advise on any Eterna Lighting
product, but may not be able to give specific
instructions regarding individual installations.
For breakage information visit:
www.eterna-lighting.co.uk
874/2012
A
MODELNO.
CF28PIR
MODELNO.
A
++
XXX
kWh/1000h
30.80
CF28PIR
A
LAMP SPECIFICATIONS:
Nominal Wattage
28W
Rated Wattage
28W
Average lifetime hours
8,000 hrs
Nominal useful luminous flux
2050 lm
Rated luminous flux
2050 lm
Luminous efficacy (Lm/W) in
50Hz operation
73
Rated lamp Lumen
maintenance
2000hrs: ≥85%
4000 hrs: ≥78%
6000 hrs: ≥76%
8000 hrs: ≥75%
Rated survival factors
2000hrs: ≥98%
4000 hrs: ≥90%
6000 hrs: ≥88%
8000 hrs: ≥50%
Lamp dimensions mm
205 x 207mm
Cap type
GR10q 4 Pin
Lamp Mercury content to an
accuracy of 0.1mg
<2.5mg
Colour rendering index Ra
≥80
Colour temperature
3500K
Ambient temperature required to
achieve maximum luminous flux
25°C
Dimmable
No
Ballast EEI
A2
