Model:
LEDBOLLARD
800mm LED Bollard
These instructions are provided as a guideline to assist you.
PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLATION
AND RETAIN FOR FUTURE REFERENCE
INSTALLATION INSTRUCTIONS
A guide for qualified electricians
EVENTUALLY, YOU MAY WANT TO
REPLACE THIS PRODUCT:
Regulations require the recycling of Waste from
Electrical and Electronic Equipment (European
“WEEE Directive” effective August 2005—UK
WEEE Regulations effective 2nd January 2007).
Environment Agency Registered Producer: WEE/
GA0248QZ.
WHEN YOUR PRODUCT COMES TO THE END OF
ITS LIFE OR YOU CHOOSE TO REPLACE IT, PLEASE
RECYCLE IT WHERE FACILITIES EXIST - DO NOT
DISPOSE WITH HOUSEHOLD WASTE.
CLEANING:
Disconnect the power and clean the exterior only of
this fitting with a moist (not wet) cloth.
Do not use any chemical or abrasive cleaners.
IF YOU EXPERIENCE PROBLEMS:
If you believe your product is defective, please return
it to the place where you bought it. Our Technical
Team will gladly advise on any Eterna Lighting
product, but may not be able to give specific
instructions regarding individual installations.
Email: sales@eterna-lighting.co.uk / technical@eterna-lighting.co.uk
Visit our website:
www.eterna-lighting.co.uk
Made in China
Issue 1216
874/2012
MODELNO.
LEDBOLLARD
Pack contents:
1 x LED fitting
3 x J bolts
3 x Base screws
3 x Washers
6 x Head screws
1 x Surface mounting
plate
LED LAMP SPECIFICATIONS:
Luminaire lumens (with diffuser)
430 lm
Lumens from chip (no diffuser)
670 lm
Useful lumens
400 lm
Rated Wattage
7W
Rated luminous flux
400 lm
Nominal life time of the lamp
30,000 hrs
Colour temperature
4000K
Number of switching cycles
before premature lamp failure
15,000
Warm-up time up to 60% of the
full light output
Instant full light
Dimmable
No
Nominal beam angle
120°
Rated power
7W
Rated lamp lifetime
30,000 hrs
Lamp power factor
0.86
Lumen maintenance factor at end
of nominal life
70%
Starting time
<0.5s
Colour rendering
>80
Colour consistency
Within a six step
Macadam ellipse
Rated peak intensity
94cd
Rated beam angle
120°
Voltage / Frequency
240V~50Hz
Not suitable for accent lighting
