7
ENGLISH
Inserting and replacing the battery
You must insert a battery to control the mouse. Proceed as follows:
1. Turn the mouse upside down, gently push the battery cover, and slide it outward.
2. Insert a new AA alkaline battery. Observe correct polarity when inserting the battery; it is
marked on the bottom of the battery compartment.
3. Replace the cover and slide it toward the center of the mouse. The correct placement of
the cover is signalled by a snap.
When you replace the battery proceed in the same way, except remove the spent battery.
The low battery LED indicator will start flashing when the battery is discharged and it needs
to be replaced.
Turning mouse On/Off
Turn the power switch on the bottom of the mouse to the "ON" position to turn on the mouse.
The LED indicator
turns on. The default operating mode is 2.4 G.
When you are not using the mouse, set the power switch at the bottom of the mouse to the
"OFF" position. This will prevent the battery from discharging prematurely.
If you will not be using the mouse for an extended period of time, turn the power switch on the
bottom of the mouse to the "OFF" position and remove the battery. This will protect the mouse
from damage if the battery electrolyte leaks.
Operating mode selection
The wireless mouse allows you to set the operating modes to 2.4 G, Bluetooth 1 or Bluetooth 2.
To select an operating mode, press the operating mode selection button at the bottom of the
mouse repeatedly in the following order:
(operating mode 2.4 G) - BT1 (Bluetooth 1) - BT2
(Bluetooth 2). The default operating mode is 2.4 G.
INSTRUCTIONS
Summary of Contents for AET-MS330SB
