15
+HEAT
Time relay, Off-delay: adjustable from 0 to 4 hours. The factory setting is 2 hours.
LOW TEMP
Set point can be set to b5 °C and +20 °C. The factory setting is +15 °C.
ACTIVATE
You start the program with
ACTIVATE
and the program will remain active until you
choose to start another program. All settings are saved in the memory and they
will not be lost even if the power is cut for longer than 48 hours, but you will
need to reset the clock for everything to function normally again. For two sec-
onds, you see a message confirming that the program has been activated. You
can then see that the program is active because
HOTEL
is shown on the second
line in display mode.
HIGH TEMP
The temperature can be set to b5 °C and +45 °C. The thermostat reacts
based on the temperature that is set in the manual program, where the factory
setting is +25 °C. If the temperature is changed in the manual program, or the
set point is changed in the
TEMP
menu, the thermostat will react based on the
new temperature.
REMOTE CONTROL
The Hotel program is controlled by a remote control device, such as a card reader,
connected to the designated terminal blocks. The thermostat switches from low
to high temperature when the device’s input circuit closes. When the input circuit
opens, the thermostat returns to the “low” set point after the set time.
System setting menu
SYSTEM
Under system settings, you will find settings for, for example, language and date,
as well as resetting functions for the time counter and for complete resetting to
factory settings. The system settings are under
SYSTEM
in the
MAIN MENU
.
Language
LANGUAGE
You can choose between several languages; the factory setting is English.
Set the required language by scrolling through them using the
or
button
and confirm with
.
You can also use the shortcuts in the display mode (press
for three seconds).
Then you go directly to the language menu. A practical function if you, by
mistake, set the wrong language and then have difficultly finding the language
menu again.
