EX17162A Unmanaged Switch Installation Guide
Copyright 2016 EtherWAN Systems, Inc.
Page 2
All Rights Reserved
E
X17162A
12/16/2014
W70G-E17162AQ2
5
Apply AC Power
A.
Connect the female end of the supplied AC
power adapter cable to the power receptacle
on the switch rear panel. Connect the other
end to a grounded 3-pronged AC outlet.
B.
On the switch rear panel, move the ON/OFF
switch to the ON position.
When you apply AC power:
All green
PoE, Link/ACT
, and
1000M
LEDs
blink momentarily.
The fans start.
The yellow
Power
LED goes ON.
The
Link/ACT
and
100M
LEDs for every port
connected to a device flash, as the switch
conducts a brief Power On Self-Test (POST).
6
Front Panel LEDs
LED
Color Status
Power
Yellow ON = switch is receiving power.
PoE
(port number)
Green ON = Power Device (PD) is connected.
OFF = PD is disconnected.
Link/ACT
(port number)
Green
ON = valid network connection.
OFF = no data transmission on port.
Flashing = port is sending or receiving
data.
1000M
(port number)
Green ON = 1000 Mbps port connection.
OFF = 10 Mbps port connection.
Flashing = 100 Mbps port connection.
Congratulations!
You have successfully
installed your switch.
NOTES:
