7 WWW.ETISSL.COM
Please contact 1-855-384-7754 or further assistance.
11
Attaching the fixture lens
□
Reattach the lens to the fixture.
□
Make sure the lens is secure.
12
Restoring Power
□
Restore power at the electrical
panel.
□
Turn on the light switch to activate
the fixture.
Care and Cleaning
CAUTION:
Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or removing the fuse from the
fuse box.
□
Clean the fixture with a soft, dry cloth.
□
Do not use cleaners with chemicals, solvents, or harsh abrasives.
□
Do not use liquid cleaner on the LEDs, LED driver, or wiring inside the light fixture.
Troubleshooting
WARNING:
Before doing any work on the fixture, disconnect power to the light fixture.
Minor problems often can be fixed without the help of an electrician.
Problem
Possible Cause
Solution
The fixture will not light.
The power is off.
Ensure the power supply is on.
The circuit breaker is off.
Ensure the circuit breaker is in the on position.
There is a bad connection.
Check to ensure proper wire connections are made.
Contact a qualified electrician.
There is a defective switch.
Contact a qualified electrician.
The LED tubes are installed incorrectly. Install LED tubes with the end labeled “power this
end” to the wired sockets.
The fuse blows or the circuit breaker
trips when the light is turned on.
The wires are crossed or the power
wire is grounding out.
Check the wire connections.
Contact a qualified electrician or call customer
service 1-855-384-7754.
Installation (continued)
