IPL ROUTER SET-UP
Ethernet ADSL Cellular Routeur Firewall
Setup Guide 9023409-01
Page 23
WiFi interface setup
Remark :
The WiFi scanner makes possible to detect the WiFi networks around the router RAS.
To use the WiFi scanner, select the Diagnostic > Tools > WiFi scanner menu.
To set-up the WiFi interface as a client to reach the Internet,
•
Select Set-up > WAN interfaces > WiFi
•
Select the « Enable » checkbox
WiFi modem set-up
« Network name (SSID) » parameter :
Enter the
name assigned to the Wi-Fi network to which the router has to connect.
Attention : The SSID is case sensitive.
« Authentification » parameter :
Select WPA or WEP or None according to the access point set-up.
« Key » parameter :
Enter the WPA or WEP key according to the access point set-up.
WiFi WAN IP set-up
« WiFi WAN priority» parameter :
Enter a medium value.
« Obtain an IP address automatically » checkbox:
Leave that checkbox selected if the IP address on the WAN interface is assigned by a DHCP server.
Otherwise unselect that checkbox and enter the IP address, the netwmask and the default gateway address.
« Obtain the DNS server IP address automatically » checkbox:
Leave that checkbox selected if the DNS servers IP addresses are assigned by a DHCP server.
Otherwise unselect that checkbox and enter the IP addresses of the DNS servers.
« NAT» checkbox :
If that option is selected, the source IP address of any IP frame coming from a device connected to the LAN
interface and routed to the WAN interface , is replaced by the router WAN IP address.
Remark: Select that checkbox if a device of the LAN interface needs to set a connection with a device
connected to the Internet (FTP server …)
