eTIGER ES-DLS-01, Manual

OTHERS

Users Operation

Programming Step

Keystroke Combination

PIN User Access:
Card User Access:
Fingerprint Access:
PIN + Card User Access:
By Remote Transmitter:

(PIN) #
(Read Card)
(Read Fingerprint)
(Read Card) (PIN) #
Press  

How to Open & Close the lock when the user is inside the door?

Programming Step

Keystroke Combination

Open the lock:
Close the lock:
By Remote Transmitter:

Touch                     on the lock
Touch                     on the lock
Press  

OPEN

CLOSE

The Wireless Lock will be locked automatically around 5 seconds after we open it. If we want to 
lock it faster, please press “0 #” on the Keypad, or press          on the Remote Transmitter, or touch
                 on the wireless lock, it will lock immediately.

Lock Immediately

(They are already paired when out of factory, if no problem, the users do not need to do this 
operation in using.) 

Pair Wireless Keypad / Remote Transmitter with Wireless Lock

CLOSE

Note: 

1. The Wireless Lock can pair 16 parts ( Remote Transmitter) maximum.

              2. When pairing, all parts must be paired, then exit paring mode. If need adding one more 
                  part, you still need to pair all parts again.

Step 1: Enter pairing mode

                  Open the battery cover of Wireless Lock, press the small round button left of battery 
                  with a slender rod, hold it for 2 seconds until hearing two beeps, that means in the 
                  pairing status.

Step 2: Pairing Wireless Keypad

                  Press the button “0 #” on the keypad, hold it for 2 seconds until hearing two beeps from 
                  Lock, that means pairing successfully.

Step 3: Pairing Remote Transmitter

                 Press any button on the Remote Transmitter, hold it until hearing two beeps from Lock, 
                 that means pairing successfully.

Step 4: Exit pairing mode

                 After pairing all parts, press the small round button in the Wireless Lock again, hold it 
                 until hearing two beeps, that means exit pairing successfully.