eTIGER ES-DLS-02, Quick Start Manual

Change PIN

Programming Step

Keystroke Combination

1.Change PIN: 
    By Card(There will be auto allocate 
    PIN (8888) to cards when adding)
                      OR
    Change PIN: By User ID

2. Exit:

Note: Below is done outside programming mode, users can undertake this themselves

*  (Read Card) (Old PIN) # (New PIN) #
(Repeat New PIN) #

*  (User ID) # (Old PIN) # (New PIN) #
(Repeat New PIN) # 
Exit automatically

Add Users PIN(s)

Programming Step

Keystroke Combination

1. Enter Program Mode:
2. Add PIN:

3. Exit:

User ID: 0~499
PIN length: 4~8 digits

* (Master Code) # 
1 (User ID) # (PIN) # (Repeat PIN) #
The users can be added continuously
*

Add Users Card(s)

Programming Step

Keystroke Combination

1. Enter Program Mode:
2. Add Card: 
     Using Auto ID(Allows to assign Card 
     tonext available User ID number)
                      OR
2. Add Card: 
     Select Specific ID(Allows Master to 
     define a Specific User ID to associate 
     the card)
3. Exit

User ID: 0~499
Card type: 13.56MHz M1 Card

* (Master Code) # 
1 (Read Card) # 
The cards can be added continuously.

1(User ID) # (Read Card) #

*

Add finger print (s)

Programming Step

Keystroke Combination

1.Enter Program Mode:
2. Add fingerprint: 
     Select Specific ID(Allows Master to 
     define a Specific User ID to associate
     the fingerprint)
3. Exit:

User ID: 0~499

* (Master Code) # 
1(User ID) #(Readfingerprint)#(Read 
fingerprint)# 

*