ETNA EKV1802WIT, Instructions For Use Manual

The food is too warm.

Interior lighting does 
not work.

Unusual noises.

The compressor does 
not  start  immediately 
after  changing  the 
temperature setting.

Water on the floor or 
storage shelves.

Temperature is not properly 
adjusted.

Door was open for an 
extended period.

A large quantity of warm food 
was  placed  in  the  appliance 
within the last 24 hours.

The appliance is near a heat 
source.

Light bulb is defective.

Door  seal  is  not  air-tight
(possibly after reversing the 
door).

Appliance is not level.

The appliance is touching the 
wall or other objects.

A component, e.g. a pipe, on 
the  rear  of  the  appliance  is 
touching  another  part  of  the 
appliance or the wall.

This is normal, no error has 
occurred.

Water drain hole is blocked.

Please look in the “initial Start Up” 
section.

Open the door only as long as 
necessary.

Turn the temperature regulation 
to a colder setting temporarily.

Please look in the “installation 
location” section.
Please look in the “changing the 
Light Bulb “section.

Carefully  warm  the  leaking 
sections  of  the  door  seal  with  a 
hair  dryer(on  a  cool  setting).  At 
the same time shape the warmed 
door seal by hand such that it sits 
correctly.

Readjust the feet.

Move the appliance slightly.

If necessary, carefully bend the 
component out of the way.

The compressor starts after a 
period of time.

See the “cleaning and care” 
section.

Warning! 

If the LED light bulb is 

damaged, only a qualified electrician 
of competent person must carry out 
it!

Changing the light bulb

Heavy  build-up  of 
frost, possibly also on 
the door seal.

  9

Changing  the  LED  light  bulb  carry  out  by 
inexperienced  persons  may  cause  injury  or 
serious  malfunctioning.  it  must  be  replaced 
by  a  qualified  persons  in  order  to  avoid  a 
hazard.  Contact  your  local  Service  Force 
Center for help.

Before changing the light bulb, switch 
off the appliance and unplug it, or pull 
the fuse or the circuit breaker.

LED light bulb data: 220-240 V.
To  switch  off  the  appliance,  set  the 
temperature regulator to position “0”.
Unplug the mains plug.
Press the bulb in the center with finger.
Take  out  the  lampshade  with  “1”  type 
screwdriver, change the bulb, and then 
replace the lampshade.
Put the refrigerator back into operation.