ETNA EVV0842WIT, Instructions For Use Manual

21

PREPARING FOR USE

Before you can use the appliance

Position

Place the appliance in a location where the 

ambient temperature corresponds to the 

climate classification for which it is designed. 

You can find the climate classification on the 

circuit-diagram-serial-plate. The following 

table shows this climate classification and its 

matching ambient temperature:

SN 

10 - 32 °C (cold environment)

N 

16 - 32 °C (normal)

ST 

16 - 38 °C (semi-tropical)

T 

16 - 43 °C (tropical)

Place the appliance on a flat and stable 

surface.

Make sure that there is sufficient ventilation, 

leave a space of 10 cm around the appliance.

You can level the appliance using the 

adjustable feet.

Leave the appliance to stand for at least 

3 hours before you insert the plug into the 

socket.

Important

When the plug has been 

disconnected from the socket or in 

case of a power failure, you have 

to wait for 3 to 5 minutes before 

switching on the appliance. If you switch on 

the appliance before this time has elapsed, 

the freezer will not function.

Cleaning

First, ensure that the interior is clean and 

dry. For cleaning, use the suds of a neutral 

cleansing agent (a general detergent or 

washing-up liquid). After cleaning, rinse the 

interior with clean water and rub dry.

Leave the appliance to dry for 1 or 2 hours.

Set the thermostat in the NORMAL position. 

Insert the plug into the socket. The appliance 

now cools continuously until the set 

temperature has been reached. 

Setting the temperature

The knob is marked with the settings MIN 

(least cold), NORMAL and MAX (coldest).

Fast freezing

If you want to freeze large amounts of food at 

the same time, you can use the MAX setting. 

Turn the thermostat to a lower setting when 

the food is frozen.

MIN

MAX

NORMAL