ETNA EVV0851WIT, Manual

17

MAINTENANCE

Changing the direction in which 
the door opens

1.  Adjust the two levelling feet to their 

highest position. Tilt the refrigerator 

backwards and rest it on something solid. 

Attention:

 Do not lay the refrigerator 

completely flat as this may damage the 

coolant system.

2.  Undo the 3 screws and remove the lower 

hinge.

3.  Slide the door down about 15 cm until it 

comes loose from the upper hinge and 

remove the door.

4.  Remove the blanking plates covering the 

handle screws. Remove the screws and 

then remove the handle.

5.  Remove the blanking plates from the 

opposite side of the door. 

6.  Fit the handle to the other side of the door 

with the 2 screws. Replace all the blanking 

plates.

7.  Using a flat bladed screw driver remove 

the pin from the top hinge. Replace it in the 

hinge on the opposite side.

8.  Remove the screw from the side of the 

refigerator where the hinge is to be 

re-fitted and replace it on the other side.

9.  Slide the door back on to the top hinge, 

making sure that the upper hinge pin fits 

into the upper hole of the door. 

10. Fit the lower hinge to the other side of the 

refrigerator.

11. Check that door is aligned horizontally and 

vertically and that the seals are closed 

on all sides before finally tightening the 

bottom hinge. Level the appliance with the 

adjustable feet.