EN 23
FAULTS
Faults table
When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the
points in the following table.
Symptom
Possible cause
Solution
The refrigerator emits a slight
odour when used for the first
time.
New appliance.
This is normal and disappears
when the appliance starts
cooling.
The appliance does nothing;
the lighting is not lit.
Plug not in socket.
Insert the plug in the socket.
Temperature inside
refrigerator too high or too
low.
Thermostat setting incorrect.
Adjust the thermostat
properly.
The door seals are dirty or the
seals are damaged.
Clean the door seals. Call
the service centre if the door
seals are damaged.
Water runs from the
refrigerator.
Defrost water drain clogged.
Clean defrost water drain (see
"Defrost").
Appliance makes a noise.
Incorrect positioning of food
in the refrigerator (or freezer).
Place foods in the proper
manner in the refrigerator or
freezer.
There is an object against the
appliance.
Remove the object.
The LED lighting does not
work.
LED lamp faulty.
Consult a service technician
about LED lighting that is not
working. For safety reasons,
you are not allowed to repair
LED lighting yourself.
This product contains a light
source of energy efficiency
class E.
Ice building up.
Freezer compartment door not
closed properly.
Make sure that the door is
closed properly.
The door seals are dirty or the
seals are damaged.
Clean the door seals. Call the
service centre if the door seals
are damaged.
Summary of Contents for KCD6178NF
