EN 7
Installation
•
WARNING!
This appliance should only be connected by a
registered installer.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied with the appliance.
• Always be careful when you move the appliance because it is
heavy. Always wear safety gloves.
• Make sure the air can circulate around the appliance.
• Wait at least 4 hours before connecting the appliance to
the power supply. This is to allow the oil to flow back in the
compressor.
• Do not install the appliance close to radiators or cookers, oven
or hobs.
• Do not install the appliance where there is direct sunlight.
• Do not install this appliance in areas that are too humid or too
colds, such as the construction appendices, garages or wine
cellars.
• When you move the appliance, lift it by the front edge to avoid
scratching the floor.
•
WARNING!
When positioning the appliance, ensure the supply
cord is not trapped or damaged.
SAFETY INSTRUCTIONS
Summary of Contents for KKV143 Series
Page 90: ...EN 24 ...
Page 91: ...EN 25 ...
Page 92: ...866149 VER 1 15 07 2021 866149 www etna nl www etna be ...