3.
Characters
Closed-loop sensor controls the temperature and zero triggering without interfering with the
voltage
With the special metal (anti-erosion and heat-resistant) and the life putting into service for lead
free is long
Heating speed is rapid and the temperature is stable and accuracy
Smart design and it is easy to use.
4.
Specifications Q200/Q400
Power:
200/400W
Size of the solder pot:
￠
36 H40mm /
￠
54 H38mm
Temperature range:
150
℃
~500
℃ /
150
℃
~450
℃
Temperature stability:
±5
℃
Weight:
1kg /1.34kg (including power cord)
Dimension:
91(L)*150 (W)*75 (H) mm / 190(L)*115 (W)*75 (H) mm
5.
Operation
Warning: the using voltage must be identical with the rated voltage of the escutcheon.
1)
Put the solder pot on the flat workbench which is heat-resistant or put a metal plate under the
solder pot
2)
Put condign soldering tin to the pot and the maximal position of the soldering tin must be
under the pot’s top 5mm
3)
Connect with the three wire-grounding socket
4)
Turn on the power knob and then the unit comes to heat. At the time, the red LED is on
5)
Adjust the temperature-adjusting knob to the needed temperature scale
6)
It needs spend some time to melt the soldering tin, such as ten minutes from 25
℃
to 300
℃
. It
can put into service when the soldering tin has melted and the LED is twinkle or darkle. If there
are some oxides floating on the surface, it must clear off the oxides and keep the soldering tin
clean
7)
It must turn off the power switch to cool the unit after finishing work
6.
Temperature calibration
It should be recalibrated after replacing the pot or the heating element.
1)
Set the temperature of the unit to 300
℃
2)
When the temperature of the unit stabilizes, dip the outer temperature sensor of the
thermometer into the pot and view the value when the temperature of the thermometer
stabilizing
3)
If the value of the thermometer’s temperature is not 300
℃
, calibrating the temperature. Use a
straight – edge (-) screwdriver or small plus (+) screwdriver to adjust the screw (marked CAL)
until the thermometer indicates a temperature
of 300
℃
. Turn the screw clockwise to reduce
the temperature and counterclockwise to increase the temperature
