9
can easily recall those data for use. Parameters to be stored include Output voltage value, Output current value,
Over Voltage Protection level, Over Current Protection level, Over Voltage Protection status, Over Current
Protection status and the Delay time.
Press
[Menu]
button
until “Utility Store” is shown on the LCD
. Use the numeric buttons to input the memory
address to save the data, then press
[Enter]
to complete the store.
For example: Store the setting data to the memory address of 5.
Press
[5] [Enter]
.
3.8.8 Recall the Setting Data
Press
[Menu]
button
until “Utility Recall” is shown on the LCD
. Use the numeric buttons to input the memory
address to recall the data, then press
[Enter]
to complete the recall.
For example: Recall the setting data from the memory address of 5.
Press
[5] [Enter]
.
Note:
When a setting is recalled, the output automatically turns off.
3.8.9 Software Version
Press
[Menu]
button
until “
Utility
Version” is shown on the LCD
. The instrument software version is displayed at
the same time.
3.8.10 Remote Sensing Setting
When the load is consuming large current, there will be voltage drop on the connecting cable between terminals of
power supply and the load. In Constant Voltage mode, the remote sensing function automatically compensates
voltage drop on the connecting cable.
Before using the remote sensing function, make sure that the power supply is under remote sensing mode. Before set on
the remote sensing function, the output must be turned OFF. The remote sensing cable is suggested to use twisted-pair
cable and do not twist the remote sensing cable with connecting cable of the load.
Press
[Menu]
button
until “
Utility Sense
” is shown on the LCD
. Press
[
] [
]
or rotary knob
to turn on or off the
remote sensing function.
