70
Disassemble the driven sprocket, axle, and sprocket collar.
Check the driven sprocket for damage or wear.
Place the rear axle on V-blocks and check the run out. The run
out limit is 0.5 mm (0.0197 in)
Check the bearing by turning with your fingers.
The bearings should turn smoothly and quietly. Replace if
necessary.
REAR BRAKE CALIPER REMOVAL
Remove the left-hand side rear wheel. Remove the two bolts
from the caliper.
Remove the caliper from the rotor.
Inspect the brake pads.
To reinstall, refer to section 10.5.
www.Get2itParts.com
www.Get2itParts.com
www.Get2itParts.com