6
Disassambly:
To
remove
the
tweeter
element
from
the mounting
cabinet, place two flat screwdrivers to the limit in both openings right
and left of the tweeter element and prize out the element.
2.
Surface
mounting:
Drill three holes for the fastening screws and one
hole for the leading connector cable using the mounting cabinet as
a guide. Consider the preferred incline of the mounting cabinet.
Mount the parts as shown in
figure 2.
Attention: If sheet metal must be cut or removed contact your
authorized car dealer for professional advice. By damage to sup-
porting body structures the safety certificate may be withdrawn.
Whenever you run wires through sheet metal, use tape or grommets to properly
insulate the metal edges from cable jackets. This technique prevents chafing
and possible short circuits that could damage an amplifier or the loudspeakers.
1.
Follow the wiring diagrams
figures 4
to connect the loudspeaker
system to your automobile radio and possibly to an amplifier. Be very
careful of correct polarity of all connections. (+ to +, - to -)
The tweeters should only be installed through a crossover.
2.
Replace the automobile battery connector and test the loudspeaker
system.
Please use only the enclosed crimp-type terminals when connecting
and do not solder them to avoid possible damage to the components.
Caution: Do not apply power to the tweeters without first installing
crossovers.
ELECTRICAL INSTALLATION
