After riding your unit, be sure to clean any build up
of mud, sand and dirt from the brake rotor skid
plate. This will protect the rotor disc from rust and
corrosion.
To Fill the Reservoir
Remove the reservoir cover by removing the two
cover bolts.
Fill the reservoir to 1/8" from top with Dot-3
SAE-J 1703 grade brake fluid.
Refold the cover gasket as shown in picture and
replace cover and bolts
Caution: DO NOT
allow dirt to fall into the
reservoir
wheel rotates while the brakes are applied, check
your fluid level and brake pads. If the brake lever
feels spongy or does not stop when squeezed,
you may have air in the lines. All air must be
purged from the brake lines for the disc brake to
operate properly. (See purging brake lines).
lever and trying to push the unit forward. If the
Test the brakes by applying pressure to the brake
when the unit is setting on a level surface.
The fluid level should fill at least of site glass
/
4
3
reservoir by checking the site glass for the level.
wear or leaks. Check the fluid level in the fluid
Visually inspect the brake hose for any signs of
Rear Brake System Inspection
Page 18
Brake Fluid Resivour Site Glass
Summary of Contents for EXL-50 - SERVICE
