Page 23
INSPECTION
STARTING PROCEDURE & WARM UP
Park the vehicle on a level surface.
Begin with a pre-start routine, easily remembered
as BONE-C:
B-Brake (set the parking brake)
O-On( insert the key and turn on the ignition; turn the fuel valve to "ON")
N-Neutral (make sure the ATV is in neutral with the green light on)
E-Engine stop switch( move the switch to "ON" )
C-Choke (since Vehicle has an automatic choke, you need only push the throttle lever slightly
when starting the engine)
Push the start button on the left handle bar.
After warming up the engine, release the parking brake. The vehicle is now ready for riding.
BREAK-IN YOUR NEW E-TON ATV
During the first two weeks of riding, go gently.
Do not run at high speeds.
Do not approach the maximum RPMs during the break-in period.
Failing to adequately break-in your E-TON ATV will decrease the long- term power and life
of the engine.
Before you ride, know your ATV. Make sure you are familiar with all controls and their operation.
Check the ATV's condition before (and after) every ride. It only takes a few minutes and could save your life.
long sleeve, long pants
over-the-ankle boots
gloves
helmet
eye protection
Warm up your muscles. For flexibility, do a few simple stretching exercise.
Check fuel level.
Check tires condition and pressure.
Check throttle for smooth opening and closing.
Check steering to see that the wheels can turn properly.
PROTECT YOURSELF
Wear protective riding gear and clothing :
Check brake operation.
Check the drive chain's condition and slack.
Check all nuts, bolts and other fasteners.
Summary of Contents for EXL-50 - SERVICE
