68
ITX-E8 User`s Manual
PnP/PCI Configuration Setup
This section describes configuring the PCI bus system. PCI, or
P
ersonal
C
omputer
I
nterconnect, is a system which allows I/O devices
to operate at speeds nearing the speed the CPU itself uses when
communicating with its own special components. This section covers
some very technical items and it is strongly recommended that only
experienced users should make any changes to the default settings.
Phoenix – AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
PNP OS Installed
[
No
]
Reset Configuration Data [Disabled]
Resources Controlled By
[Auto(ESCD)]
x IRQ Resources
Press Enter
PCI/VGA Palette Snoop [Disabled]
Assign IRQ For VGA
[Enabled]
Assign IRQ For USB [Enabled]
Item Help
Menu Level
Select Yes if you are using
a Plug and Play capable
operating system Select No
if you need the BIOS to
configure non-boot devices
↑↓→←
: Move Enter: Select +/-/PU/PD: Value F10:Save ESC: Exit F1:General Help
F5:Previous Values F6:Fail-safe Defaults F7:Optimized Defaults
PNP OS Installed
Select Yes if you are using a Plug and Play capable operating system
Select No if you need the BIOS to configure non-boot devices.
The choice: No, Yes.
Reset Configuration Data
Default is Disabled. Select Enabled to reset Extended System
Configuration Data (ESCD) when you exit Setup if you have installed
a new add-on and the system reconfiguration has caused such a serious
conflict that the OS cannot boot.
The choice: Enabled, Disabled.
Summary of Contents for ITX-E8
