background image

FWT-8888 is a GSM to Analog Converter, the device can produce a FXS line to allow a regular 

phone to be connected and used just like a local landline(PSTN) except your calls will go out the 

GSM network. This device can both receive and make calls.   

The main application is: Connecting the RJ-11 FXS line to VoIP gateway such as Clarent, Cisco, 

Quintum or Vocaltech etc. to realize VoIP call termination. It is not a VOIP gateway, It is a GSM 

Fixed Wireless Terminal that produces a Analog FXS phone line.   

Available in GSM 900/1800Mhz dual band, GSM 900/1800/1900Mhz Tri-band, 

GSM850/900/1800/1900Mhz Quadband. 

 

 

1, Front Picture                                                          2, Rear Picture 

 

 

3, Front Picture with Antenna connection              4, Bottom side picture 

1), 

Front side

 has 8pcs RJ-11 ports, and LEDs display for Signal strength, Power, Working 

Status and Talking indicator;    2),

 Rear side

 has 8pcs SMA antenna connectors, Power switch 

for every terminal, General Power port and switch; 3), 

Front side with 8pcs antennas

, this only 

for display picture, in installation, antenna must be put beyond 1.5 from terminal. Can’t be put on 

the terminal, otherwise it will make noise; 4),

 Bottom side

 has 8pcs Sim card holder slots, you 

can insert Sim card for each slot when installation. 

2,Features:

   

1) It is a 8 channels GSM Gateway that has 8 ports FXS interfaces.   

2) It can connect with ordinary telephone set, PBX , VOIP Gateway, Billing meter etc. 

3) Dialing tone frequency:450hz 

Summary of Contents for FWT-8888









Reviews: