3
5. Plug in the humidifier.
A. If an ETS Automatic Humidity Controller (Model 5100 or Model 5200)
is being used to control the humidity,
plug the humidifier into the AC
outlet on the rear of the unit labeled INCREASE.
B. If no controller is being used, then plug the unit into a standard AC
outlet of appropriate voltage.
NOTE
230 VAC Model 5462 Systems :
The 230 VAC version of the
Model 5462 must be operated with the provided 230 VAC to 115
VAC step-down transformer
ONLY!!!
Plug the transformer into a
230 VAC outlet (or 230 VAC humidity controller output), then plug
the humidifier into the 115 VAC side of the transformer. NEVER
plug the humidifier directly into a 230 VAC outlet, the humidifier is
meant for operation at 115 VAC only.
The Model 5472 is available as 115 VAC or 230 VAC, 50/60 Hz The
voltage must be specified at the time of purchase
.
The circulating fan is supplied at the appropriate voltage, 115 VAC
or 230 VAC.
4.0 MODEL 5462
The Model 5462 Ultrasonic Humidifier is a direct replacement for the ETS
Model 562 or 5612 Ultrasonic Humidifier.
4.1 SET-UP
1. Fill the water tank.
Distilled or Deionized water ONLY!!
Remove the water tank from the humidifier unit and inspect it for small
cracks or any other damage that may have occurred during shipping (a
small crack will allow air to enter the tank, which can cause the water to
overflow the basin and possibly damage the unit). After inspection, fill the
tank ¾ full with distilled or deionized water ONLY (user provided).
NOTE: Using tap water will destroy the ultrasonic transducer and the
associated electronics. Tap water will also cause a white dust
to form on all surfaces (including the humidity sensor, which
will also be destroyed).
