27330-01A
26
Problem
Solution
Sunbed not tanning
Lamps fail to light and timer dis-
play is blank
The last minute of tanning time
does not count down from 59 sec-
onds, but some time less than 59
seconds
One or more lamps fail to light
The face tanners will not
come on
The canopy will not stay up /
The canopy will not stay down
My canopy opens and closes too
fast (slamming, not enough resis-
tance)
I forgot what address, or “id”, I set
my sunbed to
1. Clean sunbed, see
Thorough Periodic Cleaning
.
2. Ensure supply voltage is between 208 and 230V AC.
3. Replace lamps if lamp hours are greater than 800hrs.
4. Replace acrylic.
1. Make sure the unit is connected to a power source.
2. Check source of AC power. Reset circuit breaker or replace fuse.
If the timer button has been pressed to decrease tanning time
during the session, the time expired in the current minute is
subtracted from the last minute.
1. Check that lamp is installed correctly.
2. Switch unlit lamp with a lamp that lights, if new lamp lights
and old lamp still does not, replace old lamp.
1. Face tanner operation is initially delayed by 5 seconds.
2. Face tanners will not relight until cooled.
3. Replace face tanner lamp, see
Removing/Replacing Face
Tanner Lamps
.
Your sunbed uses a smooth gliding spring lift system to raise
the canopy. This lift system may need to be adjusted slightly
from time to time. See
Final Adjustments
for proper adjustment
procedures. The canopy should raise easily as well as rest fully
closed.
Your sunbed utilizes a damper which limits the canopy’s
movement speed. This also serves as a safety device in case of
spring lift failure as the canopy will not crash down. Replace
the damper on back of unit.
By holding the body fan button for 3 seconds the timer display
will briefly display three numbers; the installed timer software
version, a factory set timer code and then the sunbed’s “id”
number.
Troubleshooting
