1
27330-01A
Installation
Unpacking and Inspection
The bench and canopy are each wrapped
in plastic. Remove the plastic and, with a
helper or two, grasp the canopy and pull
it from the carton bottom. Do the same for
the bench.
Do not attempt to lift either
unit with the plastic still on as it may slip.
The endcaps on the canopy should not be
used to lift the unit.
The ballast tray is
secured to the carton bottom with brack-
ets. Remove these brackets from the bal-
last tray with a Phillips screwdriver.
Note! The cartons are reusable. You may
wish to save them for future use.
After unpacking the unit, check to make
sure you have received the following:
• Canopy unit
• Bench unit
• Rear lamp module
• Ballast tray
• Access panel
• Two large bench endcaps
• Body fan kit
• Shoulder tanner kit
• Two bags containing necessary
assembly hardware, safety goggles, a
pillow and a tube of touch-up paint.
Inspect these items, including the canopy
and bench, to make sure they are free
from any visible damage. Report the
extent of any damage to the transportation
company.
Record the serial number of the unit in the
area provided at the back of this manual.
This information will be required whenev-
er you call customer service.
Tools Required
You will need the following tools to
assemble your sunbed.
#2 Phillips Screwdriver
-AND-
9/16” and 7/16” Wrenches
-OR-
Adjustable Wrench
