29731-03A
25
Care and Maintenance - Lamp and Grill Maintenance
Lamp and Grill Maintenance
Introduction
To be assured of maximum tanning effective-
ness, change lamps after approximately 600-
800 hours of use. Tanning will continue after
this time but at a slower rate.
To ensure
trouble-free operation of your sunbed,
replace the lamp starters whenever the
lamps are replaced.
Removing/Replacing Metal Grills
The metal grills are secured in place by two
screws at the top of each grill. Simply remove
these screws and lift the grill out of its chan-
nel at the bottom. Repeat for the other grills.
The long inside handles will also need to be
removed to remove the left and right module
grills. The lamps are now exposed.
After changing the lamps, replace the metal
grills by reversing the directions.
Removing/Replacing Lamps
After removing the metal grills, replace lamps
as follows.
Step 1
Grasp the lamp at one end and at
the middle and turn the lamp one
quarter turn. Gently remove the
lamp from its holders.
Step 2
Reinstall the lamp by inserting the
pins located on the ends of the
lamp into the slots on top of the
lamp holders and turn the lamp a
quarter turn. It should click in
place.
Recommended Replacement Lamps
We recommend using the lamps specified
below. Use of uncertified lamps is a violation
of Federal regulations and will void your war-
ranty. These lamps have an average life of
600-800 hours of effective tanning use. Lamps
used longer than that begin to lose their effec-
tiveness even though they continue to light.
THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THIS EQUIPMENT:
BRONZING SUN™ PLUS Wolff® Model BSP71-T12-160W VS-R BI-PIN
WARNING
Shock hazard.
Disconnect power before removing
any protective covers.
Summary of Contents for SunDome 548V
Page 1: ...29731 03A...
Page 31: ...29731 03A 26 Notes...
Page 33: ...29731 03A...
Page 34: ...29731 03A...
