7
123914-01-05/15 (translation of the original operating instructions)
Operating Instructions
Key Adapter CKS-K-AS2A-U-C20-PC
EN
7. Mounting
NOTICE
Risk of damage to equipment and malfunctions as a result of incorrect installation.
Ì
To achieve the degree of protection IP 67, it is necessary to install the key adapter in a clean,
flat metal plate at least 2 mm thick and to tighten the screws with a tightening torque of 0.25 ...
0.35 Nm.
Ì
The device may be damaged if the tightening torque applied exceeds 0.35 Nm.
Ì
A suitable strain relief must be provided for the connection cables in order to avoid damage to the
connection sockets or malfunctions.
The key adapter is intended for mounting in control panels with a cut-out measuring 33 mm x 68 mm according to DIN 43700.
The device is fastened using screw clamp elements from the rear side of the panel.
1. Insert the key adapter, with seal already bonded in place, into the mounting cut-out from the front.
2. Insert screw clamp elements in the housing of the key adapter from the side up to the end stop and tighten with
0.25 … 0.35 Nm.
3. After mounting, again check the key adapter for firm seating and correct sealing of the front panel.
