U2829 Series Operation Manual Chapter 3 Introduction to [DISP]
19
OFF
2)
Select one of above soft keys to set the compare function as ON or OFF.
3.2.2
FUNC
Parameter zone shows the “Function” parameter, if user selects primary and
secondary parameter swap compare mode, the parameter will be displayed as
swap parameter, such as: “Cp-D” is displayed as “D-Cp”, which means the current
D is compared as primary parameter while Cp is compared as secondary
parameter.
3.2.3
NOMINAL
Nominal parameter is the nominal value used to make bin compare.
3.2.4
BIN
This zone shows the bin number of the limit list. “2nd” means the secondary
parameter limit.
3.2.5
HIGH/LOW
This zone shows the high and the low limits of the limit list.
3.2.6
COUNT
This zone shows the count value of the current bin.
3.2.7
AUX
This zone shows the count value of the auxiliary bin.
3.2.8
OUT
This zone shows the count value of the out bin.
Operation steps for bin count function
Execute the following operations to set the bin count function ON/OFF on <
BIN
DISPLAY
> page.
1)
On <
BIN DISPLAY
> page, move the cursor to
COUNTER
zone, the
following soft keys will be displayed.
ON
OFF
