U2836 Operation Manual Chapter 3 Introduction to [MEAS DISP]
14
3.1.6
Output Impedance
The output impedance of U2836 can be set as 30
Ω
,30
Ω
and 100
Ω
.
Operation steps for setting output impedance:
3)
Move the cursor to RSOU, the following soft keys will be displayed:
100
Ω
50
Ω
30
Ω
4)
Use above soft keys to set the output impedance.
3.1.7
Tools
The test result of U2836 is displayed as 6 floating-point digits. Decimal point lock
function can make U2836 output the test result in fixed way. Meanwhile this
function can change the displayed count of test result. This displayed result can
be selected to be shown in large character or small character.
Operation steps for tools
Set the display mode of decimal point in fixed mode according to the following
operation steps. Also the character size of test result can be set.
1)
Move the cursor to TOOL zone, the following soft keys will be displayed:
D.P.FIX A
D.P. FIX B
DISP OFF ON
EASY
START SAVE CSV
2)
Press
D.P.FIX A
to lock the decimal location of primary parameter TEST
result. When the decimal location is locked,“ ”
▲
is displayed. Press
D.P.FIX A
once
，
the last digit will be deleted, and the displayed digit will be reduced by
one.
3)
Press
D.P.FIX B
to lock the decimal location of secondary parameter TEST
result. When the decimal location is locked,“
▲
” is displayed. Press
D.P.FIX B
once
，
the last digit will be deleted, and the displayed digit will be reduced by
one.
4)
Press
EASY
to display the test results on easy operation page. On the easy
operation page, the numeric keys( 1 to 9) is response 9 measurement setup.
5)
Press
DISP OFF ON
to close/open the display of the test results.
———————————————————————————————————————
NOTE: Under the following circumstance, the function of decimal lock will be
cancelled automatically to recover to floating decimal point status.
Test function is changed.
In deviation test, the deviation test mode (
Δ
ABS,
Δ
%, OFF) is changed.
———————————————————————————————————————
