U2836 Operation Manual Chapter 2 Introduction
4
Chapter 2
Introduction
In this chapter, the basic operation features of U2836 are described. Please read
the content carefully before using U2836 instruments, thus you can learn the
operation of U2836.
2.1
Introduction to front panel
Figure 2-1 shows the front panel of U2836.
1)
POWER
Power switch
2)
Brand and model
Brand and model
3)
USB HOST interface
Connect U flash disk so as to save or use a specified file.
4)
[MEAS SETUP]
Press this key to enter into the setup page of measurement setup.
5)
[SYSTEM]
Press this key to enter into the system setup page.
6)
Ground terminal
The ground terminal is connected with the case of instrument, which can be
used to protect or shield the ground connection.
7)
Test terminals (UNKNOWN)
4-teminal test pair are used to connect 4-terminal test fixture or cable to
measure DUT.
The 4 terminals are respectively as follows: Hcur, Hpot, Lpot and Lcur.
8)
[ENTER]
This key is used to end the input of data, and confirm and save the data
displayed on the inputting line (the bottom line on LCD).
