U2836 Operation Manual Chapter 2 Introduction
5
9)
[TRIG]
When the trigger mode is set to MAN mode, press this key to trigger the
instrument.
10)
[LOCK/LOCAL]
Press this key, the buzzer will beep, which means the function of current
panel is locked. Press it again, it will be off, which means discharging the lock
status. If the password function is ON, it means correct password is
necessary when discharging the key-lock, or the key cannot be unlocked.
11)
[CLEAR]
Execute the calibration operation. Press this key to execute OPEN/SHORT
calibration.
12)
[ESC]
ESCAPE key
13)
[
←
]
BACKSPACE key is used delete the last numeric of the input value.
14)
Numerical keys
These keys are used to input data to the instrument. The key consists of
numerical keys [0] to [9], decimal point [.] and [+/-] key.
15)
FAIL indicator
LED indicator shows the test result has failed.
16)
CURSOR
This key is used to move the cursor on the LCD displayed page. When the
cursor moves to a zone, the corresponding zone will be lightened.
17)
PASS indicator
LED indicator shows the test result has passed.
18)
[MEAS DISP]
Press this key to enter into the display page of measurement display.
19)
Soft keys
Five soft keys are used to select parameters. The corresponding function of
each soft key has been displayed on its left (the right part of LCD). The
function definition varies with different pages.
20)
LCD
480*272 colorful TFT LCD displays measurement results and conditions.
