8
• After use, store the bicycle rack in a clean and dry place. Wash off any dirt with water.
• Check the bicycle rack attachment regularly for damages. Damaged or worn parts must be replaced immediately.
Only original replacement parts may be used.
• Check the bolts and nuts of the bicycle carrier regularly and tighten when necessary.
• Immediately treat any damage to paintwork with paint.
6. Maintenance and care
7. Notes regarding environmental protection
8. Contact information
Please dispose of this device via the recycling bin or the public/municipal collection points.
The materials are recyclable. You make an important contribution to protecting our environment by recycling, material utilisation
or other forms of reusing waste equipment!
Image 7: Holding bracket
Open the frame holder of the mounting bracket by turning the knob nut counter-
clockwise. Fold the mounting bracket down and place it on the wheel track. Place the
bicycle in the wheel track, with the front wheel on the side of the mounting bracket‘s
base plate. Push the bicycle back into the wheel track until you can raise the mounting
bracket in front of the bicycle frame. Adjust the angle of the mounting bracket so that
it forms a right angle with the bicycle frame, Image 7. Now push the bicycle forwards
until the frame is situated in the mounting bracket‘s frame holder. Close the frame
holder by folding the threaded bolt into the intake of the opposite rail. Now securely
tighten both screws. Lock the upper knob nuts.
Position the tension belts around the bicycle‘s wheel rims and lock the clasp. Firmly
tighten the tension belts.
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
