Page 6 / 16
5.
Operating Instructions
5.1
Assembly
5.1.1 Handlebar assembly
The handlebars of the Miniped are pre-assembled
and just need to be attached to the head tube. Do to
so, loosen the screw (A) and remove the protective
cap (C), see
Image 1.
Place the handlebars onto the
head tube.
ATTENTION:
The electrical cables and
brake lines cannot be twisted, kinked or
clamped.
Straighten the handlebars and tighten both screws (B). Place the screw (A) back in the control head and
tighten it.
5.1.2 Pedal assembly
The pedals are marked with the letter "R" for the
right and "L" for the left side, see
Image 2.
The right
pedal has a right-hand thread, the left one has a left-
hand thread. Screw the right pedal clockwise into
the threaded hole of the right pedal crank. Screw the
left pedal counter-clockwise into the threaded hole
of the left pedal crank.
5.1.3 Rear mudguard assembly
Place the mudguard on the frame of the back wheel.
Align it with the mounting holes and screw it tight
with both screws,
Image 3
.
5.1.4 Battery assembly
Insert the key into the lock on the right
side of the
battery and turn in a counter-clockwise motion as far
as it will go,
Image 4.
The battery locking
mechanism is now completely open.
Image 3: Back mudguard
Image 4: Opening the locking
mechanism
Image 2: Labelling on the pedals
Image 1: Assembling the
handlebars
