EUFY RoboVac 11, Owner'S Manual

08

09

2. Remove objects within 3 ft/1 m of the left and right side and within 6 ft/2 m of the front 

of the charging base.

3. Connect the round connector of the adapter into the power socket on the Charging Base 

and the other end into a wall outlet.

T

- Install the Charging Base in a 

location that RoboVac can easily 

access.

- Always keep the Charging Base 

plugged in, otherwise RoboVac 

will not automatically return to it.

Charge Your RoboVac

•  RoboVac has a pre-installed rechargeable battery that has to be fully charged before use.
•  Robovac returns to the Charging Base at the end of a cleaning cycle or when its battery is 

running low.

•  Manually charge RoboVac when its battery is fully discharged or if it fails to reach the 

Charging Base. 

Method 1: 

Attach RoboVac to the Charging Base by aligning its charging pins with the 

charging pins on the base.

Before You Start

1.  Remove the protective film covering RoboVac and the Charging Base. 

2. Flip RoboVac over and snap on the side brushes.

Install the Charging Base

1.  Place the Charging Base on a hard, level surface and against a wall.