DF64 Digital Frame Manual
Version 1.0 ©1999 Euphonix, Inc.
Page 10
used to determine which card is Active and which is on stand-by.
5V, 3V LEDs
Indicate that 5 volt and 3 volt power are present.
Reset Button
This button forces a manual reset of the FC631 card.
Error LED
Indicates that an error condition has been detected on the
FC631. It is normal for this LED to remain lit for 30 seconds or
more after the DF64 is powered on.
HotSwap Button
Push this button prior to making a swap of the FC631
Card. In a system fitted with two FC-631 cards, the backup card
will take over when the HotSwap button is pressed on the active
card (supported in v2.0).
Ready LED
Indicates that FC631 is disconnected from the DF64
system bus and ready for removal.