8.2 Transport mode
8.2.1 How transport mode works
In transport mode, the Wi-Fi data logger logs data to internal memory as long as batteries are inserted and have sufficient
charge. In transport mode, it is possible to set a start transport flag and a stop transport flag, which is shown on the web
platform and can be used to indicate whenever transport started and ended, which in turn can be used to export reports on
the measured temperatures during transport.
The measurements are always ongoing and can not be stopped, so the use of transport start and stop flags does not influence
the actual measurements.
8.2.2 Placing a start flag
To set the start flag on the Wi-Fi data logger, hold the ‘e’ button until the Wi-Fi icon starts blinking, release immediately. If the
start flag set is done correctly, the Wi-Fi icon will blink green 3 times to indicate that the start flag has successfully been set.
8.2.3 Getting status during transport
When a start flag has been set, it is possible to get the current status by pushing the ‘e’ button shortly. The status can be read
via the following table:
Symbol Color
Symbol
Status
Red Wi-Fi & Thermometer
Low battery. The battery should be
replaced as soon as possible.
Red Thermometer
Indicates that the transport start flag
has not been set.
Yellow Thermometer
Since the transport start flag was set,
there has been a violation of the
temperature limits.
Green Thermometer
Indicates that no violations of limits
have occurred since the transport
start flag was set.
8.2.4 Placing an end flag
To set an end of transportation flag, push the button for about 3 seconds until the Wi-Fi icon blinks red, release and push
again until the Wi-Fi icon blinks red. If the end of transportation flag is correctly set, the Wi-Fi icon will then blink yellow 3
times.
User Guide: Eupry Wi-Fi Data Logger
Rev. 0.8 - May 2021
Page 10 of 12
Eupry ApS | Dortheavej 59. 3. | 2400 Copenhagen | www.eupry.com/ | +45 53 51 77 00 |
support@eupry.com
