Clean Motor Filter
Clean the motor filter after each cleaner use.
1. Remove the filter frame from the dust cup.
2. Shake and brush the dust and dirt from filter.
3. If desired, remove filter from filter frame and launder the filter by hand in warm water
(150
7
F, 65
7
C) using a mild detergent.
4. Air dry thoroughly.
5. Replace filter over frame.
Replace a dirty or torn filter. Order additional motor filters from The Eureka
Company, Bloomington, IL 61701.
Order motor filter, part number 60684.
§
§
Remove Battery Pack for Disposal
For information 1-800-282-2886
Ni-Cd
NOTE: Remove the battery pack only when the batteries no longer hold
a charge and you plan to dispose of them.
CAUTION: Do not short circuit or dispose of in fire. Dispose of properly.
A municipal waste will not dispose of the battery pack. Use a recycling center if
one is convenient. Otherwise, take or send the battery pack to your nearest Eureka
Warranty Service Station. To learn the address of the nearest factory service center
call 1-800-282-2886.
1. Lay cleaner down on its top.
2. Unscrew the one screw on the bottom, flip unit to the right and unscrew the screw on
the side of the handle.
3. Grasp handle with thumb on battery cover. Using thumb push down and slide battery
cover toward wrist. This will loosen the battery cover so it can be freed from the
cleaner.
4. Remove battery pack and dispose of properly. For more information call
1-800-282-2886.
8
Summary of Contents for 78A
Page 10: ......