Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
4
How to replace brush roll or belt
1) Step on handle release to lower handle
flat onto floor (Fig.1).
2) Remove 4 screws from brush roll cover.
(Fig. 2).
3) Lift off brush roll cover. (Fig. 3).
4) Remove brush roll and belt. Thread new
belt around motor shaft and brush roll
(Fig. 4).
5) Insert left end of brush roll first. Make
sure end cap fits into base. Pull right side
of brush roll to stretch belt and insert
right end cap into base (Fig. 5). Make
sure it slides into position.
6) Rotate brush roll 2 turns to center belt.
7) Replace brush roll cover (Fig. 3).
8) Replace 4 screws (Fig. 6).
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 1
How to maintain your vacuum cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged.
Check U belt. Replace if worn, cut or out of shape.
Avoid touching the motor shaft when checking brush roll or belt.
!
!
Maintain brush roll
Motor pulley can become hot with normal use.
Remove hair and threads from brush roll periodically. Do not remove end caps.
Hose blockage
1) Remove hose from hose retainer. Flex the
hose to loosen any blockage (Fig.1).
2) Remove dust cup. Set air path knob to
‘floors.’ Use finger to check for debris. (Fig 2)
3)
Base hose
– Pull down to loosen end of
base hose. Use finger to clear blockage.
Snap hose end back up into position (Fig 3).
4)
Hose connector
– Pull out on left side
tab to remove connector. Remove debris.
Align tab at right and snap connector
back into place (Fig. 4).
!
How to clear a blockage
Make sure vacuum is turned off and power cord is unplugged.
Fig. 1
Fig. 2
Fig. 4
Fig. 3
