Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
4
How to clean brush roll
Check brush roll periodically and remove debris.
Use scissors to clip threads or hair (Fig. 1).
How to replace brush roll
• Lay vacuum with back on floor. Remove 3 screws
(Fig. 2). Rotate brush roll plate up and lift off.
• Rotate brush roll to remove (Fig. 3).
• To install brush roll, align star end first (Fig. 4),
then position opposite end. Rotate to make
sure brush roll fits securely.
• Replace brush roll plate: Align rounded ends
in slots and rotate plate down over brush roll.
• Press plate tightly, making sure 4 hooks latch
around rod (Fig. 5).
• Replace 3 screws (Fig. 6).
How to maintain your vacuum cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged.
!
Maintain brush roll
Motor pulley can become hot with normal use.
Fig. 1
Fig. 3
Fig. 5
Fig. 2
Fig. 4
Fig. 6
Hose blockage
• Remove hose from hose retainer. Flex the hose to
loosen any blockage (Fig.1).
• Remove dust cup. Set air path knob to ‘floors.’
Use finger to check for debris (Fig 2).
•
Base hose
– Pull down to loosen end of base hose.
Use finger to clear blockage.
Snap hose end back up into position (Fig 3).
•
Hose connector
– Pull out on left side tab to
remove connector. Remove debris. Align tab at right
and snap connector back into place (Fig. 4).
!
How to clear a blockage
Make sure vacuum is turned off and power cord is unplugged.
Fig. 1
Fig. 2
Fig. 4
Fig. 3
