background image

Component List:

1 Tent / Hammock Body w/ attached hanger assembly 
2 Attached Tent Poles      1 Carry Bag   

Assembly:

• Unroll and unfold the tent/hammock and lay it on the ground with 
  the Eureka! logo up. 

fig.2

fig.3

fig.1

fig.5

fig.7

fig.6

fig.9

fig.8

fig.10

fig.4

• There is a hanger assembly that runs the 

length of the Chrysalis  [ web, buckles, 
pins & carabiners ]. Make sure that the 
webs, buckles and carabiners protrude 
through the openings at each end and 
that the pins are held by the end web 
loops. See fig.2

• Fold the roof fabric back from the door. Inside, there are two poles 

that spread and hold the tent/hammock. Remove the protective 
covers and fit the narrow end of each pole section into the sleeve on 
its opposite half. See fig. 4 and 5.

• Adjust the webs to 

provide sufficient tension 
to hold you up off of the 
ground. See fig. 6.

• Pull the roof fabric out 

and over the pole ends 
and secure to the 
underside Velcro®.          
See fig. 7.

Note:

 It is easiest to enter the Chrysalis as you 

would most other hammocks. Lift the roof over 
your head, back in and sit. Turn to bring in your 
legs and lie down.

• Once inside the tent/
  hammock, you can  “shut” 

the door by attaching the 
bottom to the Velcro® on 
the outside of the shell. 
See fig. 8.

• You can hold the 

door/mesh open by 
attaching it to the ridge 
with the Velcro® straps or 
wrap the straps over the 
top to hold the fly open. 
See fig. 9.

• Or you can release the 

toggle on the inner door 
flap, fold the flap down 
and tuck it under while 
leaving the mesh in place. 

   See fig.10

• Locate the two push up vents near one 

end of the roof. At this end, wrap the 
web around a tree at approximately 
head height and secure in place with 
the carabiner. See fig.3

• At the opposite end, again wrap the 

web around a tree and secure with the 
carabiner.  Adjust tension as necessary. 

Note: If you prefer, as you lay, to have 

your head above your feet, wrap this 
web a bit lower than the first. 

REV  B   4-09

ASSEMBLY INSTRUCTIONS for the CHRYSALIS TENT/HAMMOCK:

Pin is captured

by this loop

Take down: 

Remove the webs from the trees. Disassemble the poles and 

replace the protective covers. Align the poles across the tent/hammock. 

Leave the doors open. Fold the fabric inward. Roll up stow in the carry bag.

YOUR TENT/HAMMOCK IS READY!

The Chrysalis is 10’ 4” 

long and needs 11’ to 15’  

of distance between 

trees or supports 

Reviews: